TM/SM

Personable * Reliable * Organized * Honest * Valiant * Attentive * Contractors

©

844-PRO HVAC

PROHVAC
PROHVAC
Personable * Reliable * Organized * Honest * Valiant * Attentive * Contractors

Pricing

(HVAC Services & Labor Costs)

(Services & associated prices below do not including labor costs for energy audit sealing, the sizes of each building or home and specific causes of energy losses will vary and  are evaluated on a job by job bases.)

=

+

+

PROHVAC


                 Initial Service / Work Set Up / Travel -
$95.00
                 Thru-Wall, cut, install and seal - Property frame and siding -
$695.00
                 Thru-Wall, cut, install and seal - Property masonry -
$675.00
                 Thru-Wall Replacement, install and seal - Property masonry -
$450.00
                 Thru-Wall Replacement with additional cutting or modifications required -
$95.00 (Per Hour) 
                 Window Unit, install and seal - no panels required -
$225.00
                 Window Unit, install & seal, customized panel & window modifications required -
$325.00
                 Split System, installation for a residence - Approx. -
$2,995.00
                 Split System, installation for a small business or office & depending on overall work scope - Approx. -
$4,595.00
                 Initial Service / Work Set Up / Travel (scheduled service, time and fuel)                              
$95.00
                 Maintenance Repair - Replace duct filter -
$50.00
                 Maintenance Repair - Check for gas leaks -
$95.00
                 Maintenance Repair - Carbon Monoxide test -
$175.00
_ _____________Maintenance Repair -Check and clean standard gas furnace (oil furnace add $75.00 for filter and nozzle) - 
$185.00
                 Maintenance Repair - Check and clean standard central A/C system
                 (rooftop units add $75.00) -
$125.00
                 Heating - Replace gas valve on furnace or boiler (standing pilot) and a new thermocouple
$500.00
                 Heating - Replace gas valve on furnace or boiler (intermittent pilot or proven pilot) -
$500.00
                 Heating - Replace gas valve on furnace or boiler (Milli-volt to standard standing pilot) -
$400.00
                 Heating - Replace gas valve on furnace or boiler to intermittent pilot or
                 direct spark including ignition module wiring, pipe fittings and new pilot tubing -
$750.00
                 Heating - Replace gas valve on furnace or boiler to hot surface igniter (HSI), direct spark
$450.00
                 Heating - Replace induced draft fan motor on furnaces or boilers, includes replacement motor -
$550.00
                 Heating - Repair defective or broken HIS system with spark module -
$195.00
                 A/C - Heat-Pump Replace condenser fan motor on 1.5 to 5 ton (double shaft motors add $150.) -
$400.00
                 A/C - Heat-Pump Replace compressor 1.5 to 5 tons. Includes re- piping, additional refrigerant, replacing wires, terminals, etc. -
$2,000.00
                 A/C - Heat-Pump Electrical tune-up single phase heat pump or air conditioner;Replace contactor, add hard start kit,
                 replace damaged wiring, terminals, etc. -
$200.00
                 A/C - Heat-Pump Replace contactor single phase unit -
$75.00
                 A/C - Heat-Pump Replace contactor three phase unit -
$95.00
                 A/C - Heat-Pump Install liquid line sight glass and dryer -
$350.00
                 A/C - Heat-Pump Mechanical tune-up with liquid line sight glass, dryer, high and low pressure controls,
                 anti-restart timer (also known as the "rental property package") -
$600.00
                 A/C - Heat-Pump Mechanical tune-up replace indoor coil includes with thermostatic expansion valve,
                 hard start kit and sheet metal modifications -
$1,200.00
                 A/C - Heat-Pump Mechanical tune-up to add thermostatic expansion valves inside and out to a heat pump,
                 includes hard start kit, re-wiring and piping modifications -
$800.00
                 A/C - Heat-Pump Repair leaks on indoor coil "spider tubes", add expansion valve, high and low pressure controls,
                 anti-restart timer, start kit (2 expansion valves for heat pump add $200.) -
$600.00
                 A/C - Heat-Pump Replace condenser fan motor on 1.5 to 5 ton (double shaft motors add $150.) -
$400.00
                 A/C - Heat-Pump Install / Modify system to a heat pump (no change to existing fuel) - approx.
$2,700.00
                 A/C - Heat-Pump Install / Modify system to a heat pump (change made to 100% electric) - approx.
$3,900.00
                 New Installations - Replace / install / connect a residential furnace -
$995.00
__________New Installations - Replace / install / connect a residential central A/C condensing unit - 
$900.00
                 New Installations - Set up / install / connect a residential A/C air-handler unit -
$600.00
                 New Installations - Set up / install / connect a new 1.5 to 5 ton central A/C system -
$2,500.00
                 New Installations - Set up / install / connect a residential central A/C flex-duct system -
$1,800.00
                 New Installations - Set up / install / connect a residential boiler -
$1,950.00
                 New Installations - Set up / install / connect a residential oil tank -
$500.00
                 New Installations - Roof Curb frame work, or pre-constructed (includes roof cut) -
$725.00

                 New Installations - Roof Pitch-Pocket (includes roof cut) -

$495.00